PDA

View Full Version : Netcomm V100 Ata



ursus
28th September 2005, 07:52 PM
Netcomm V100 ATA installation software does not support macs. I am having trouble borrowing a PC to read the disc, and getting no help from netcomm support. Are there any workarounds for this? Ursus

Currawong
29th September 2005, 04:13 PM
According to the spec sheet, they can be configured using telnet. To use Telnet, open Terminal (/Applications/Utilities/Terminal.app) and, after plugging the V100 into your computer, type: telnet <ip address of V100> where the ip address is whatever it says it will be in the instruction manual.

I may be slightly off the mark here, but the instructions should give better advice.